The first step to make a paracord bracelet is to measure your wrist the rule of thumb is to use a foot for every inch the wrist is.

Next you want to put a loop down thru the clasp then double it and put both threw the same loop this will give you a clean looking start point and you need to maintain the same loop for the  body of the bracelet this will be go all the way to the other end of the bracelet and using the same loop threw and loop it back on its self  I must point out make sure both ends of the cord is the same length because this is the last time you can change it without take the whole thing apart!

Now for the main technique to make the bracelet and that is to use the same cobra design as you seen in the Mummy paracord lanyard. And repeat this till you get to the other end of the bracelet.

Now you should be at the end and it should look like this photo!

Next you want to do the same as you did when you started and that is to double it threw the clasp .

Here you want to weave the cord into its self like in the photo and tighten.

Now this part is the way I do it many people have different ways but this is the best way I have found to do it because I am more concerned with it staying in place and not coming  apart then I am with style sometimes I even put a drop of super clue just for insurance .

Now you’re almost done after you pulled it all tight you can clip off the ends and melt them into the paracord so they will not come apart and like I said you can put a small drop of super glue to make sure it’s not coming apart not needed but it never hurts