 |
Step one you want to start with two pieces of paracord with the insides taken out one is 2 feet and the other is about a half a foot longer to allow for the part that will go through the knife lanyard hole. |
||
 |
Step 2 you need to be very careful here the first knot is the most
important if the strings don’t match in size here fix it because
it will be your last chance to do so if you don’t you will be
left with one that is two small at the end to finish. |
||
 |
Step 3 the premises is simple all it is you put one under then one over locking them in by the others as you can see from the photos I took lots so you can see. |
||
 |
   |
||
 |
  |
||
 |
Step. 5 now you’re done take the ends and cut them about a quarter of a inch from the lanyard and burn them and well they are hot flatten them with a knife blade or something steel and your done now to put it on the knife! |
||
 |
Step. 6 now here is how I found it to be the easiest way to put it into the knife hole and that is to take a piece of the core of the paracord loop it threw the lanyard then put through the hole and pull and just put the lanyard threw its self again and your done !! |
||
 |
 |
||
|
|||
|
|||
If you like the products used in this how to go and Get these products from